NEC NC1000C - Page 89

89
Appendix
Error Code Error message Description
267 Fan13 Stop Precaution Fan13 Stop Precaution
268 Fan14 Stop Precaution Fan14 Stop Precaution
271 IMB:SD Tamper Terminate Terminated service door tamper event latched by IMB.
* This message would be shown on Log, not on LCD.
301 System Error ICP status error
302 Self Test Error ICP status error
305 Key Error ICP status error
306 Certificate Error ICP status error
329 FMT Sequence Data File Mismatch ICP status error
330 FMT DMD Data File Mismatch ICP status error
333 Satellite Hardware Mismatch ICP status error
335 Red Satellite Reports Reset FSB status error
336 Red Satellite Serial Link Error ICP or FSB status error
337 Red Satellite Firmware Configuration Error ICP or FSB status error
338 Red DAD1000 Bias Under Voltage Error FSB status error
339 Red DAD1000 Reset Under Voltage Error FSB status error
340 Red DAD1000 Offset Under Voltage Error FSB status error
341 Red DAD1000 Thermal Shutdown Error FSB status error
342 Green Satellite Reports Reset FSB status error
343 Green Satellite Serial Link Error ICP or FSB status error
344 Green Satellite Firmware Configuration Error ICP or FSB status error
345 Green DAD1000 Bias Under Voltage Error FSB status error
346 Green DAD1000 Reset Under Voltage Error FSB status error
347 Green DAD1000 Offset Under Voltage Error FSB status error
348 Green DAD1000 Thermal Shutdown Error FSB status error
349 Blue Satellite Reports Reset FSB status error
350 Blue Satellite Serial Link Error ICP or FSB status error
351 Blue Satellite Firmware Configuration Error ICP or FSB status error
352 Blue DAD1000 Bias Under Voltage Error FSB status error
353 Blue DAD1000 Reset Under Voltage Error FSB status error
354 Blue DAD1000 Offset Under Voltage Error FSB status error
355 Blue DAD1000 Thermal Shutdown Error FSB status error
370 ICP Frame Memory Test Result Fail ICP self test error due to “Frame memory error”
372 ICP Data Path Signature Test Result Fail ICP self test error due to “Data Path Signature Test Result
Fail”
380 DRS Error(Low Battery) FMT board low battery
* When this error has occurred, IMB can not Marriage with
the projector.
* After this error has occurred, Integrity Error will occur when
you turn on the power again.
381 SEC No Battery No communication with the secure processor.
* When this error has occurred, IMB can not Marriage with
the projector.
* After this error has occurred, Integrity Error may occur
when you turn on the power again.
500 IMB Comm Fail No communication with the IMB.
510 IMB:System Error IMB Status error
511 IMB:Self Test Error IMB Status error
519 IMB:Certificate or Key Error IMB Status error
520 IMB:ICP Communications Status IMB fails to do logical marriage to projector.
537 IMB:RTC Error IMB RTC is “invalid”.
543 IMB:FPGA Temperature out of range IMB Status error
550 IMB:Supply voltage out of range IMB Status error