NEC NC1000C - Page 90

90
Appendix
Error Code Error message Description
574 IMB:Security Tamper Security tamper condition exists in IMB.
577 IMB:Security Battery Event A Battery Tamper event has been detected with the IMB.
581 IMB:Security Enclosure Not Armed IMB security not armed.
582 IMB:Physical Marriage Tamper The IMB has detected a break of the Marriage with the
projector.
583 IMB:Logical Marriage Tamper The IMB has detected an error with the verification of the
Marriage with the projector.
584 IMB:Marriage NOT Active The IMB has not established a marriage with the projector
586 IMB:Service Door Tamper Latched service door tamper condition on IMB
588 IMB:Security Battery Low Warning Close to “(577) IMB: Security Battery Event”.
700 OPT Comm Fail Failed to communicate with Opt CPU
701 OPT Status Fail Opt CPU is in unexpected status.
702 Lamp Lit Change Any one Lamp of the two Lamps is off.
703 OPT Comm Ack Fail Opt CPU fails to execute the command.
704 LampOff Fail Failed to lamp off
710 Lamp1 OverTime Lamp1 cumulative time is over.
711 Lamp2 OverTime Lamp2 cumulative time is over.
720 Lamp1 Door Open(Warning) Lamp1 door (cover) is open while HotSwap is enabled.
721 Lamp2 Door Open(Warning) Lamp2 door (cover) is open while HotSwap is enabled.
740 SensorFail Inlet1 Failed to read inlet sensor 1.
741 SensorFail DMD Failed to read DMD sensor.
750 OverTemp.DMD Precaution Set inside temperature (DMD) is close to over temperature.
751 OverTemp.Inlet1 Precaution Set inside temperature (Inlet) is close to over temperature.
752 Down Lamp Power Activated Down lamp power to decrease set inside temperature.
753 OverTemp.Ballast1 Precaution Set inside temperature (Ballast1) is close to over
temperature.
754 OverTemp.Ballast2 Precaution Set inside temperature (Ballast2) is close to over
temperature.
760 OverTemp.DMD Set inside temperature (DMD) is abnormal.
761 OverTemp.Inlet1 Set inside temperature (Inlet) is abnormal.
762 OverTemp.Lamp Set inside temperature (Lamp) is abnormal.
764 OverTemp.Ballast1 Set inside temperature (Ballast1) is abnormal.
765 OverTemp.Ballast2 Set inside temperature (Ballast2) is abnormal.
781 Interlock Open Interlock is open.
782 SystemI2cFail Failed to control sensors connecting to GPIO chip.
(Slave board internal abnormality)
783 EepromFail Slave MCU failed to read back all of data from EEPROM on
slave MCU board due to unexpected data or something.
(Slave board internal abnormality)
785 SoftwareI2cFail I2C/UART conversion chip control failed on slave board.
(Slave board internal abnormality)
786 PreCooling Failed to precool.
787 Lamp1 Door Open Lamp1 door (cover) is open.
788 Lamp2 Door Open Lamp2 door (cover) is open.
789 Ballast1UartError Communication error between slave MCU and ballast1.
790 Ballast2UartError Communication error between slave MCU and ballast2.
791 FanInitError Failed to initialize fans.
792 ExGpioFail Failed to control the signal connecting to Ballast.
(Slave board internal abnormality)
793 Notch Filter Open Notch Filter Cover is open.
794 Inlet2 Sensor Failed to read inlet sensor 2.
800 Fan15 Stop Fan15 has stopped.
801 Fan16 Stop Fan16 has stopped.