NEC NC1000C - Page 91

91
Appendix
Error Code Error message Description
806 Fan17 Stop Fan17 has stopped.
807 Fan18 Stop Fan18 has stopped.
808 Fan19 Stop Fan19 has stopped.
809 Fan20 Stop Fan20 has stopped.
810 Fan15 Stop Precaution Fan15 Stop Precaution
811 Fan16 Stop Precaution Fan16 Stop Precaution
816 Fan17 Stop Precaution Fan17 Stop Precaution
817 Fan18 Stop Precaution Fan18 Stop Precaution
818 Fan19 Stop Precaution Fan19 Stop Precaution
819 Fan20 Stop Precaution Fan20 Stop Precaution
830 Fan21 Stop Fan21 has stopped.
850 Fan21 Stop Precaution Fan21 Stop Precaution
1000 Slave Comm Fail Failed to communicate with slave MCU.
1003 Slave Comm Ack Fail Slave fauls to execute the command.
1004 Slave Power Ready Fail Slave Power Ready error
1005 Slave No Notify Slave Power Notify error
1111 Filter1 Cleaning Time The time to clean filter1 (filter(L)).
1112 Filter2 Cleaning Time The time to clean filter2 (filter(DMD)).
1121 Filter1 Time Over The time to exchange filter1 (filter(L)).
1122 Filter2 Time Over The time to exchange filter2 (filter(DMD)).
1500 P3P3V SAT PGOOD Fail Error detected with 3.3V power supply for FSB
1501 P2P5V SAT PGOOD Fail Error detected with 2.5V power supply for FSB
1502 XVT PGOOD Fail Error detected with DDR power supply for FMT FPGA
1503 P2P5V X PGOOD Fail Error detected with 2.5V power supply for FMT FPGA
1504 P1P8V X PGOOD Fail Error detected with 1.8V power supply for FMT FPGA
1505 P1V X PGOOD Fail Error detected with 1V power supply for FMT FPGA
1506 FMT FPGA DONE Fail FMT FPGA Configuration Error
1509 EXGPIO IC602 Fail I2C Device Access Error
1510 EXGPIO IC603 Fail I2C Device Access Error
1511 EXGPIO IC604 Fail I2C Device Access Error
1512 EEPROM IC2800 Write Fail I2C Device Access Error
1513 EEPROM IC601 Read Fail I2C Device Access Error
1514 EEPROM IC601 Write Fail I2C Device Access Error
1515 EEPROM IC601 Write Fail(Verify) I2C Device Access Error
1538 EEPROM IC2800 Read Fail I2C Device Access Error
1550 EEPROM IC2800 Write Fail Verify I2C Device Access Error
2000 IntegrityFail Integrity error with the internal software code of the
projector.
* When this error has occurred, the projector will not accept
any external demands. Communication with external
devices will not be performed either.
2010 Incorrect power-off PowerOff was not performed correctly last time.
2011 No Lamp Serial Number The lamp serial number is not set.
2012 Input Lamp S/N Update the lamp serial number and clear the lamp usage
time (after using the hot swap function).