OPERATION ROI-S04488
3-34
Step
Procedure
9 Press the “1” key and “Enter” key, then, following setting menu
is displayed,
Notes: 1. In item No. 1, the required bit rate is indicated in the
parenthesis ( ) on “Bit rate”.
Bit rate (2
x
2:0 / 4
x
2:1 / 8
x
2:2 / 16
x
2:3) :3
Changing the bit rate will cause temporary
communication loss. Until the bit rate of the opposite
site is changed. The buzzer may be issued until then.
2. In item No. 2, and item No. 3, setting for AIS RCVD/
AIS SEND indication on/off .
3. In item No. 4, both channel numbers are indicates for
each No. 1 and No. 2 as No. 1: *ch / No. 2: *ch .
4. In item No. 5 shows in MTPC system, TX power ctrl
(ATPC): excepting Twin path TX power ctrl (No. 1:
ATPC / No. 2: ATPC is indicator in ATPC system.
5. In item No. 6, following significant symbol letters are
used to display the status for each channel.
“#” : signifies E1 channel which is inhibited by the
hardware restriction or LAN signal
transmission.
Setting
1. Bit rate (4×2MB)
2. AIS RCVD alarm/status (status)
3. AIS SEND alarm/status (status)
4. TX/RX frequency (5ch)
5. TX power ctrl(0dB)
6. Main channel usage 1-16 (used: UNNN NNNN #### ####)
7. BER alarm threshold (10-4)
8. Frame ID (0)
9. WS channel usage (not used)
10. DSC 1 (232)
11. DSC 2 (232)
12. DEM invert (off)
13. Alarm table
14. Next items
00. Menu
99. Exit
Select item No. :
To Next Page
Loading...
