NEC PE455UL - Page 128

7. Connecting to a Network
108
② When connecting with [INFRASTRUCTURE]
1. Turn on the power of the projector and press the APPS button on the remote controller.
The start-up screen of MultiPresenter is displayed.
2. Connect the projector and your computer or tablet terminal to the same network.
NOTE:
• Checkwiththenetworkadministratorforthe“connectioninformation”ofthenetworktobeconnected.
3. StartMultiPresenter.
The target device screen is displayed.
4. Enterthe4-digitPINcodedisplayedinthestart-upscreeninthetargetdevicescreen.
When connection with the projector is completed, the screen of the computer or tablet terminal
is projected on the screen.
③ When connecting with a [SIMPLE ACCESS POINT]
1. Turn on the power of the projector and press the APPS button on the remote controller.
The start-up screen of MultiPresenter is displayed.
2. Connect your computer or tablet terminal to the access point matching the “SSID” displayed
inthestart-upscreen.
3. StartMultiPresenter.
The target device screen is displayed.
4. Enterthe4-digitPINcodedisplayedinthestart-upscreeninthetargetdevicescreen.
When connection with the projector is completed, the screen of the computer or tablet terminal
is projected on the screen.