NEC PE455UL - Changing Eco Mode;Checking Energy-Saving Effect

3. Convenient Features
37
3-4. Changing Eco Mode/Checking Energy-Saving Effect
Using Eco Mode [ECO MODE]
Two eco modes can be selected according to the purpose of use for the projector.
[ECOMODE] Iconatthebottomof
themenu
Description StatusofLIGHTindicator
[OFF] 100%brightness
Thescreenwillbebrightlylit.
Steadygreen
light
[ECO]
Brightnesswillbeatabout60%(PE455WL:67%).
Thecoolingfanwillalsoslowdownaccordingly.
Lowerpowerconsumption
Blinkinggreen
light
[LONGLIFE]
Brightnesswillbeatabout50%(PE455WL:56%).
Thissettingaccordsprioritytoprolongingthe
lifeofthelightmodule.
To turn on the [ECO MODE], do the following:
1. Press the ECO Button on the remote control
todisplay[ECOMODE]screen.
2. Use the ▼▲ buttons to select, then press
the ENTER button.
The [ECO MODE] selection screen turns o and
the projector switches to the selected mode.
NOTE:
• The[ECOMODE]canbechangedbyusingthemenu.
 Select[SETUP]→[GENERAL]→[LIGHTMODE]→[ECOMODE].
• The[LIGHTHOURSUSED]canbecheckedin[USAGETIME].Select[INFO.]→[USAGETIME].
• Afteralapseof1minutefromwhentheprojectordisplaysno-signalguidance,ablue,blackorlogoscreen,theprojectorgoesinto
[LONGLIFE]automatically.Theprojectorwillreturntoitsoriginalsettingonceasignalisaccepted.
• Iftheprojectorinsidetemperaturebecomeshighcausedonthehighroomtemperature,theprojectormaydecreasethebrightness
temporarilyforprotectingitself.Thisisaprotectivefunctioncalled[FORCEDECOMODE].Whentheprojectorisinthe[FORCEDECO
MODE],thethermometersymbol[
]isindicatedattherightbottomofthescreen.Whentheprojectorinsidetemperaturegoes
downbycoolingtheroom,the[FORCEDECOMODE]willbereleasedandtheprojectorwillbebacktotheoriginalsettingstate.