NEC PE455UL - Using On-Screen Menu; Using the Menus

48
4-1. Using the Menus
NOTE:
• Theon-screenmenumaynotbedisplayedcorrectlywhileinterlacedmotionvideoimageisprojected.
1. Press the MENU button on the remote control or the projector cabinet to display the menu.
NOTE:
• ThecommandssuchasENTER,EXIT,▲▼,◀▶inthebottomshowavailablebuttonsforyouroperation.
2. Press the ◀▶ buttons on the remote control or the projector cabinet to display the
submenu.
3. PresstheENTERbuttonontheremotecontrolortheprojectorcabinettohighlightthe
top item or the rst tab.
4. Usethe▲▼ buttons on the remote control or the projector cabinet to select the item you
want to adjust or set.
You can use the ◀▶ buttons on the remote control or the projector cabinet to select the tab
you want.
5. Press the ENTER button on the remote control or the projector cabinet to display the
submenu window.
6. Adjust the level or turn the selected item on or o by using the ▲▼◀▶ buttons on the
remote control or the projector cabinet.
Changes are stored until adjusted again.
7. Repeat steps 2–6 to adjust an additional item, or press the EXIT button on the remote
controlortheprojectorcabinettoquitthemenudisplay.
NOTE:
• Whenamenuormessageisdisplayed,severallinesofinformationmaybelost,dependingonthesignalorsettings.
8. Press the MENU button to close the menu.
To return to the previous menu, press the EXIT button.
4. Using On-Screen Menu