NEC PE455UL - Page 133

7. Connecting to a Network
113
⑥ NETWORK SERVICE
Congure the [AMX BEACON], [HTTP SERVER], [PJLink], [ALERT MAIL], [CRESTRON] and other settings.
Item name Description
AMX BEACON Select whether or not to transmit AMX beacons.
• Initialvalue:OFF(donottransmit)
HTTP SERVER Set the password to log into the projector’s HTTP server.
• Initialvalue:Blank
• Allowablecharacters:Alphanumericsymbols
• Numberofcharacters:0–10characters
When a password is set, a number of asterisks “*” equivalent to the number of
characters is displayed.
PJLink Set the PJLink password.
PASSWORD SETTINGS Set the PJLink password.
• Initialvalue:Blank
• Allowablecharacters:Alphanumericcharacters
• Numberofcharacters:0–32characters
When a password is set, a number of asterisks “*” equiva-
lent to the number of characters is displayed.
ALERT MAIL Set alert mail and perform a transmission test.
ALERT MAIL Select whether or not to send an alert mail when an alert
target event occurs in the projector.
• Initialvalue:OFF(donottransmit)
SENDER'S ADDRESS Set the sender’s address when sending E-mail from the
projector.
• Initialvalue:Blank
• Allowablecharacters:Alphanumericcharacters,
symbols
• Numberofcharacters:0–60characters
SMTP SERVER NAME Set the SMTP server of the network to connect to the
projector.
• Initialvalue:Blank
• Allowablecharacters:Alphanumericcharacters,
symbols
• Numberofcharacters:0–60characters
RECIPIENT'S ADDRESS
1/2/3
Set the destination address to send E-mail from the
projector (maximum 3).
• Initialvalue:Blank
• Allowablecharacters:Alphanumericcharacters,
symbols
• Numberofcharacters:0–60characters
TEST MAIL Send a test mail according to the settings.