NEC PE455UL - Page 92

4. Using On-Screen Menu
72
TurningOnorORemoteSensor[REMOTESENSOR]
Set the remote control sensors on the projector’s front and rear panels.
The options are: [FRONT/BACK], [FRONT], and [BACK].
TIP:
• Iftheremotecontrolsystemdoesnotfunctionwhendirectsunlightorstrongilluminationstrikestheremotecontrolsensorofthe
projector,changeanotheroption.
• Theremotecontrolsensoronthebackoftheprojectorcannotbeusedwhentheseparatelysoldcablecoverismountedonthe
projector.
SettingIDtotheProjector[CONTROLID]
You can operate multiple projectors separately and independently with the single remote control
that has the [CONTROL ID] function. If you assign the same ID to all the projectors, you can conve-
niently operate all the projectors together using the single remote control. To do so, you have to
assign an ID number to each projector.
CONTROLIDNUMBER Selectanumberfrom1to254youwishtoassigntoyourprojector.
CONTROLID Select[OFF]toturnothe[CONTROLID]settingandselect[ON]toturnonthe[CONTROLID]
setting.
NOTE:
• When[ON]isselectedfor[CONTROLID],theprojectorcannotbeoperatedbyusingtheremotecontrolthatdoesnotsupportthe
CONTROLIDfunction.(Inthiscasethebuttonsontheprojectorcabinetcanbeused.)
• Yoursettingwillnotbeaectedevenwhen[RESET]isdonefromthemenu.
• PressingandholdingtheENTERbuttonontheprojectorcabinetfor10secondswilldisplaythemenuforcancelingtheControlID.