Utilities 2-3
How to Start Setup
To start the Setup utility, follow these steps:
1. Turn on or reboot the system.
2. Press
F2
after POST begins, but before the system boots up. You have about
five seconds to press
F2
.
Setup’s Main Menu window appears similar to the following screen.
Note:
The screen shown is typical of a system. The
actual settings on the Main Menu depend upon the hardware
installed in the system.
Main Setup Menu
How to Use Setup
The Setup utility has a Main Menu window and six top-level menus with
submenus.
The Main Menu window contains the following areas:
A title line the top line of the Main Menu. This line displays the Setup
utility name and copyright message.
The menu bar the line under the Setup title line. The menu bar
contains six top-level menus to set system parameters.
To Next Page
Loading...
