Utilities 2-15
Exit Menu
The Exit Menu allows you to choose how to exit the Setup program. Press the
arrow (cursor) keys to select the desired option, then press
Enter
to make your
choice (or use the arrow key to select another one).
Exit Saving Changes
This option exits the Setup program and saves your changes to the BIOS.
Exit Discarding Changes
This option exits the Setup program without saving your changes to the
BIOS.
Load Setup Defaults
This option loads the Setup program’s default values.
Load Custom Defaults
This option loads Custom default settings.
Save Custom Defaults
This option saves your changes to Custom default settings.
Discard Changes
This option loads previous values from CMOS RAM for all BIOS
settings.
Note:
If your system’s CMOS fails, the BIOS will load
custom default settings (if you’ve saved them) or factory
default settings.
Finally, press
Enter
again to confirm and exit the Setup program.
Intel Processor Serial Number Control Utility
The Intel Processor Serial Number Control utility is a Windows program that
enables or disables the reading of the Pentium III processor serial number by
software. This function lets you control which software programs or websites
have permission to read the processor serial number. When installed, the utility
runs automatically each time the system powers on.
Note
: The Intel Processor Serial Number Control Utility
is for use with systems shipping with the Intel Pentium III
processor. Installing this utility on a system which does not
contain a Pentium III processor generates an error message.
To Next Page
Loading...
Need help?
General
