NEC Univerge SV8100 - Page 1015

UNIVERGE SV8100 Issue 5.0
Transfer 1 - 1005
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-58 Service Code Setup (for Service
Access) – Transfer into
Conference
Use this program to assign the
code users dial to Transfer a call
into a Conference call.
MLT, SLT
(default = not
assigned)
11-15-09 Service Code Setup
Administrative (for Special
Access) – Transfer to Incoming
Ring Group
When a call is transferred using
this service code, it is transferred
to the ring group destination for
that incoming trunk. For example,
trunk 2 is in Ring Group 4. When
the call is transferred using this
service code, the trunk rings all
extensions programmed for Ring
Group 4 or ring the External
Paging Group for Ring Group 4,
depending on how the system is
programmed.
(default not assigned)
15-02-05 Multiline Telephone Basic Data
Setup – Transfer Key Operation
Mode
Use this option to set the operating
mode of the extension Conf key.
The keys can be for Call Transfer
(0), Serial Calling (1) or Flash (2).
When selecting the Flash option,
refer also to Program 81-01-14.
0 = Transfer
1 = Call back
2 = Hook
(default = 0)
15-02-24 Multiline Telephone Basic Data
Setup – Conference Key Mode
This option allows an extension
Conf key to be programmed for
Conference or for Transfer. When
set for Transfer (1), the user
places a call on hold, dials the
extension to which it should be
transferred, the presses the Conf
key. The call is then transferred.
When set for Conference (0), with
an active call, the user presses the
Conf key, places a second call,
then presses the Conf key twice.
All the calls are then connected.
0 = Conference
1 = Transfer
(Default = 0)
15-07-01 Programmable Function Keys Extension users may want a
function keys programmed for
Transfer (code 06).
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-02-04 System Options for Multiline
Telephones – Retrieve the Line
After Transfer
Enable (1) or disable (0) an
extension ability to answer a call
after it is transferred, but before it
is answered.
0 = Not Holding (No
Keep)
1 = Holding (Keep)
(default = 1)