NEC Univerge SV8100 - Page 1016

Issue 5.0 UNIVERGE SV8100
1 - 1006 Transfer
20-03-01 System Options for Single Line
Telephones – SLT Call Waiting
Answer Mode
For a busy single line (500/2500
type) telephones, set the mode
used to answer a camped-on trunk
call.
Modes:
0 = Press and release hookswitch
to pick up waiting call
1 = Press and release hookswitch
and dial Service Code 894 (Call
Waiting Answer/Split Answer for
SLT) to answer waiting call.
0 = Hookflash
(Hooking)
1 = Hookflash +
Service Code 894
(default = 0)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turn Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-06 Class of Service Options (Hold/
Transfer Service) – Unscreened
Transfer (Ring Inward Transfer)
Turns Off (0) or On (1) an
extension ability to use
Unscreened Transfer.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-07 Class of Service Options (Hold/
Transfer Service) – Transfer
Without Holding
Turns Off or On an extension
ability to use Transfer Without
Holding.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-11-08 Class of Service Options (Hold/
Transfer Service) – Transfer
Information Display
In an extension Class of Service,
turn Off or On the incoming
Transfer preanswer display.
0 = Off
1 = On
(default = 1 for COS
01~15)
20-11-11 Class of Service Options (Hold/
Transfer Service) – Automatic
On-Hook Transfer
In an extension Class of Service,
turn On (1) or Off (0) the ability to
use Automatic On-Hook Transfer.
If enabled, user must press Hold
and dial the extension number to
Transfer the call. If disabled, a
user must have a Transfer
Programmable Function Key. To
transfer the call, the user would
press Hold, dial the extension
number, then press the Transfer
Programmable Function key to
complete the transfer.
0 = Off
1 = On
(default = 0 for
COS 1~15)
Program
Number
Program Name Description/Comments Assigned Data