NEC Univerge SV8100 - Page 1018

Issue 5.0 UNIVERGE SV8100
1 - 1008 Transfer
20-18-07 Service Tone Timers – Intrusion
Tone Repeat Time
After a user barges in, the system
repeats the Barge-In tone after this
interval. Normally, you should
disable this time by entering 0.
(This time also affects any other
call interruption features, such as
Voice Mail Conversation
Recording, Voice Over, etc.)
0~64800 (seconds)
(default = 0 seconds)
21-01-03 System Options for Outgoing
Calls – Trunk Interdigit Time
(External)
Program the time an extension
must wait before the Barge-In
feature can be used on a call (this
time expires before putting a call in
a talk state). This time also affects
Voice Over.
0~64800 (seconds)
(default = 5 seconds)
22-04-01 Incoming Extension Ring Group
Assignment
Assign extensions to ring groups. Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
22-05-01 Incoming Trunk Ring Group
Assignment
Define a trunk ring group. When
transferring a DID or trunk call to
the trunk defined ring group, the
trunk then rings the defined
extensions for the ring group.
Incoming Group
Number for Day/Night
Mode (1~8):
0 (No Setting)
001~100
(Incoming Group)
102 (In-Skin/ External
Voice Mail or VM8000
InMail)
(default = 1)
22-08-01 DIL/IRG No Answer Destination Assign the DIL No Answer Ring
Group to which an unanswered
call should overflow.
0 (No Setting)
001~100
(Incoming Ring Group)
102 (In-Skin/
External Voice Mail
or VM8000 InMail)
(default = 1)
24-02-01 System Options for Transfer –
Busy Transfer
Disable (0) or enable (1)
extensions to transfer calls to busy
extensions. If disabled, calls
transferred to busy extensions
recall immediately.
0 = Disable (No)
1 = Enable (Yes)
(default = 1)
Program
Number
Program Name Description/Comments Assigned Data