NEC Univerge SV8100 - Page 1027

UNIVERGE SV8100 Issue 5.0
Trunk Group Routing 1 - 1017
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-01-01 System Numbering – Service
Code
Set up a Service Code for
Alternate Trunk Route Access.
Refer to Univerge
SV8100 System
Program Manual
11-09-01 Trunk Access Code – Trunk
Access Code
If required, change the single-digit
Trunk Access Code (normally 9). If
you change this code, you must
also review the settings in
Program 11-01 for the new code
selected.
Dial (up to four digits)
(default = 9)
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
Assign the Service Code set up in
Program 11-01 for Alternate Trunk
Route Access.
Dial (up to four digits)
(default not assigned)
14-05-01 Trunk Group – Trunk Group
Number
Assign trunks to trunk groups. Trunk Group Number:
0~100 Priority Number:
1~200 (default = Trunk
Group 1, with priority in
ascending order.)
14-06-01 Trunk Group Routing – Priority
Order Number
Used to set the priority order
number 1~4.
0 = Not Specify1~100 :
(Trunk Group
Number)1001~1100 :
(1000 + Route Table
Number)
Default:
Route 1, Order
Number 1 = 1 (Trunk
Group 1)
Order Numbers 2, 3, 4
= 0 (Not Specified)
All Other Routes
(2~100) and Order
Numbers (1~4) = 0
(Not Specified).