Issue 5.0 UNIVERGE SV8100
1 - 1030 Trunk Queuing/Camp-On
Central Office Calls, Placing
Programmable Function Keys
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-04 Service Code Setup (for Service
Access) – Set Camp-On
Customize the Service Code,
which is to be used for setting
Camp-On.
MLT, SLT
(default = 850)
11-12-05 Service Code Setup (for Service
Access) – Cancel Camp-On
Customize the Service Code,
which is to be used for cancelling
Camp-On.
MLT, SLT
(default = 870)
11-16-05 Single Digit Service Code Setup
– Camp-On
Customize the 1-digit Service
Code used for setting Camp-On.
(default not assigned)
15-07-01 Programmable Function Keys Assign a function key for Trunk
Queuing and Trunk Camp-On
(code 35).
Trunk Groups: 1~100
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-01-08 System Options – Trunk
Queuing Callback Time
Set the Trunk Queuing Callback
Time. Trunk Queuing Callback
rings an extension for this interval.
0~64800 (seconds)
(default = 15 seconds)
20-01-09 System Options – Callback/
Trunk Queuing Cancel Time
Set the Callback/Trunk Queuing
Cancel Time. The system cancels
an extension Callback or Trunk
Queuing request after this interval.
0~64800 (seconds)
(default = 64800
seconds)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
20-11-07 Class of Service Options (Hold/
Transfer Service) – Transfer
Without Holding
Turns Off or On an extension
ability to use Transfer Without
Holding.
0 = Off
1 = On
(default = 0 for
COS 1~15)
To Next Page
Loading...
