NEC Univerge SV8100 - Page 1058

Issue 5.0 UNIVERGE SV8100
1 - 1048 Uniform Call Distribution (UCD)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-09-07 Class of Service Options
(Incoming Call Service) – Call
Queuing
Turn Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is busy.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-17 Class of Service Options (Hold/
Transfer Service) – Department
Group Trunk-to-Trunk Transfer
(Each Telephone Group
Transfer)
Turn On (1) or Off (0) the ability of
an extension in a Department
Group to use the Trunk-to-Trunk
Forwarding service codes.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
manually (0) or automatically (1)
receive Off-Hook Signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-14 Class of Service Options
(Supplementary Service) –
Department Calling (PLT No
Called Extension)
Turns off or on an extension user
ability to call a Department Group
Pilot.
0 = Off
1 = On
(default = 1 for
COS 1~15)
22-02-01 Incoming Call Trunk Setup If you want a trunk to be a DIL to a
Department Group, assign Service
Type 4 for each Night Service
Mode. Also see Program
22-07-01.
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-07-01 DIL Assignment For each trunk assigned Service
Type 4 in Program 22-02 above,
assign the DIL destination as the
Department Group pilot number
(as assigned in Program
11-07-01). (Department: Groups
1~64).
Extension Number
(maximum eight digits)
(default not assigned)
Program
Number
Program Name Description/Comments Assigned Data