NEC Univerge SV8100 - Page 1065

UNIVERGE SV8100 Issue 5.0
Uniform Numbering Network 1 - 1055
44-03-02 Dial Analysis Extension Table –
ARS/F-Route Select Table
Number (1~250)
When dialed digits match the
setting in Program 44-03-01,
select the ARS/R-Route table
number (0~500) to be used for the
Dial Extension Analysis Table.
0~500
(ARS/F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
44-03-03 Dial Analysis Extension Table –
ARS/F-Route Select Table
Number (251)
If the received digits are not
identified in tables 1~250, the
F-Route selection table number
(0~500) defined in table 251 is
used.
0~500
(ARS/F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
44-03-04 Dial Analysis Extension Table –
Next Table Area Number (252)
If the received digits do not match
the digits set in tables 1~250, table
number 252 is used refer to the
next Extension Table Area (1~4) to
be searched.
0~4
(default = 0)
44-04-01 ARS/F-Route Selection for Time
Schedule
Assign each ARS/F-Route
Selection number (1~500) to an
ARS/F-Route table number for
each ARS/F-Route time mode.
There are eight time modes for
ARS/F-Route Access.
ARS/F-Route Time
Mode: 1~8
ARS/F-Route Table
Number = 0~500
(default = 0)
44-05-01 ARS/F-Route Table – Trunk
Group Number
Select the trunk group number to
be used for the outgoing ARS call
(1~100).
0~100, 255
0 = No Setting
255 = Extension Call
(default = 0)
44-05-02 ARS/F-Route Table – Delete
Digits
Enter the number of digits to be
deleted from the dialed number
[0~255 (255 = Delete all)].
0~255
(255 = Delete All)
(default = 0)
44-05-03 ARS/F-Route Table – Additional
Dial Number Table
Enter the table number (defined in
Program 44-06) for additional
digits to be dialed (0~1000).
0~1000
(default = 0)
44-05-04 ARS/F-Route Table – Beep Tone For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Select whether or not a
beep is heard if a lower priority
trunk group is used (0 = No Beep,
1 = Beep).
0 = Off
1 = On
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data