NEC Univerge SV8100 - Page 1075

UNIVERGE SV8100 Issue 5.0
UNIVERGE Multimedia Conference Bridge 1 - 1065
Operation
Setup Procedures
To set the Supervisor Password:
1. Call the Conference Bridge extension number, and wait for the voice prompt.
2. Dial the default Supervisor Password (0 0 0 0), then dial #.
3. Follow the voice prompt, and enter the setting verification mode (#). Then enter system set mode.
4. Follow the voice prompt to change Supervisor Password (4~8 digits).
To set the Conference 1 and/or the Conference 2 Password:
1. Call the Conference Bridge extension number, and wait for the voice prompt.
2. Dial the default Supervisor Password (0 0 0 0), then dial #.
3. Skip the steps until Conference Setup mode is available for conference 1 or conference 2.
22-02-01 Incoming Call Trunk Setup Assign Service Type 4 to each
trunk you want to ring into the
Multimedia Conference Bridge as
a Direct Inward Line (DIL).
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-07-01 DIL Assignment Assign the master/pilot number of
the Conference group from
Program 11-07-01 as the DIL
destination. If all Conference ports
are in the same unique Extension
(Department) Group (see Program
16-02 above), the DIL will ring
another Conference port if its
assigned port is busy.
Extension Number
(maximum eight digits)
(default not assigned)
Program
Number
Program Name Description/Comments Assigned Data