NEC Univerge SV8100 - Page 113

UNIVERGE SV8100 Issue 5.0
Automatic Route Selection 1 - 103
14-05-01 Trunk Group – Trunk Group
Number
Program trunks of the same carrier
type into the same trunk group.
Trunks 1-200
Trunk Group 1-100
Priority - 1-200
(default = All trunks in
Trunk Group 1 with
priorities of:
Trunk 1 = Priority 1
Trunk 2 = Priority 2
Trunk 200 = Priority
200)
14-07-01 Trunk Access Map Setup Set up the Trunk Access Maps.
This sets the access options for
trunks.
0 = No access
1 = Outgoing access
only
2 = Incoming access
only
3 = Access only when
trunk on Hold
4 = Outgoing access
and access when trunk
on Hold
5 = Incoming access
and access when trunk
on Hold
6 = Incoming and
Outgoing access
7 = Incoming access,
outgoing access and
access when trunk
on Hold
Trunk Access Maps:
1~200
Default:
Access Maps 1~200 =
Trunk Ports 1~200
assigned with option 7
access (incoming and
outgoing access and
access when trunk is
on Hold).
15-06-01 Trunk Access Map for
Extensions
Assign Trunk Access Maps to
extensions.
Trunk Access Maps:
1~200
(default = 1)
20-03-04 System Options for Single Line
Telephones – Dial Sending Start
Time for SLT or ARS
When ARS or an analog extension
user accesses a trunk and dials an
outside call, the system waits this
interval before outdialing the first
digit.
0~64800 (seconds)
(default = 3 seconds)
Program
Number
Program Name Description/Comments Assigned Data