NEC Univerge SV8100 - Page 1137

UNIVERGE SV8100 Issue 5.0
Voice Response System (VRS) 1 - 1127
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
20-07-13 Class of Service Options
(Administrator Level) – VRS
Record (VRS Msg Operation)
Turns Off (0) or On (1) an
extension ability to record, erase
and listen to VRS messages.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-07-14 Class of Service Options
(Administrator Level) – VRS
General Message Play
Turns an extension Off (0) or On
(1) to dial 4 or Service Code 711 to
listen to the General Message.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-07-15 Class of Service Options
(Administrator Level) – VRS
General Message Record/Delete
Turns Off (0) or On (1) an
extension for dialing Service Code
712 and record, listen to, or erase
the General Message.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-15 Class of Service Options (Hold/
Transfer Service) – VRS
Personal Greeting (Message
Greeting)
In an extension Class of Service,
enable (1) or disable (0) the ability
to dial Service Code 716 to record,
listen to or erase a Personal
Greeting. This option also affects
Park and Page.
0 = Disable
1 = Enable
(default = 1 for
COS 1~15)
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
Select whether an extension
should display the reason a call is
being transferred to their
extension (Call Forward Busy, Call
Forward No Answer, DND).
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-15-11 Ring Cycle Setup – VRS Waiting
Message Incoming Call
Set the ring cycle callers hear
when the VRS Waiting Message
feature is used.
Ringing Cycle = 1~13
(default = 6)
21-01-02 System Options for Outgoing
Calls – Intercom Interdigit Time
When placing Intercom calls,
users must dial each digit within
this time.
0~64800 (seconds)
(default = 10 seconds)
22-01-10 System Options for Incoming
Calls – VRS Waiting Message
Operation
Determine whether the VRS
Waiting Message is automatically
(0) or manually (1) set.
0 = Enable Always
1 = Change by Manual
Operation
(default = 0)
22-01-11 System Options for Incoming
Calls – VRS Waiting Message
Interval Time
For VRS Waiting Message,
determine the number of seconds
between the VRS messages
(0~64800).
0~64800 (seconds)
(default = 20 seconds)
Program
Number
Program Name Description/Comments Assigned Data