NEC Univerge SV8100 - Page 1138

Issue 5.0 UNIVERGE SV8100
1 - 1128 Voice Response System (VRS)
22-02-01 Incoming Call Trunk Setup For each Night Service mode,
enter 1 if trunk should be
automatically answered by VRS
Automated Attendant.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-04-01 Incoming Extension Ring Group
Assignment
Use this program to assign
extensions (up to 32) to Ring
Groups. Calls ring extensions
according to Ring Group
programming.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No other
extensions ring for
incoming Ring Group 1
calls.
22-14-01 VRS Delayed Message for IRG –
1st Waiting Message Start Time
For each Ring Group, set how
long the system waits before
playing the first message
(0~64800 seconds). This timer is
also used for VRS Waiting
Message.
0~64800 (seconds)
(default = 0)
22-14-02 VRS Delayed Message for IRG –
1st Waiting Message Number
For each Ring Group, select the
message number to be played as
the first message (001~100). This
program is also used for VRS
Waiting Message.
0~101
0 = No Message
101 = Fixed Message
(default = 0)
22-14-03 VRS Delayed Message for IRG –
1st Waiting Message Sending
Count
For each Ring Group, set the
number of times the first message
is played (0~255). This program is
also used for VRS Waiting
Message.
0~255 (time)
(default = 0)
22-14-04 VRS Delayed Message for IRG –
2nd Delayed Message Number
For each Ring Group, select the
message number to be played as
the second message (001~100).
This program is also used for VRS
Waiting Message.
0~101
0 = No Message
101 = Fixed Message
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data