NEC Univerge SV8100 - Page 118

Issue 5.0 UNIVERGE SV8100
1 - 108 Automatic Route Selection
26-11-01 Transit Network ID Table –
Transmit Network ID (Carrier ID)
Enter the Transit Network
Selection information element to
be added to an ARS call using an
ISDN trunk. This information
element identifies a requested
transit network.
0000~9999
(Fixed four digits)
(default not assigned)
44-01-01 System Options for ARS/F-Route
– ARS/F-Route Time Schedule
Select whether the ARS/F-Route
feature should use the time
schedule (0=not used, 1=used). If
this option is set to 0, the F-Route
table selected is determined only
by the digits dialed without any
relation to the day or time of the
call. If this option is set to 1, the
system first refers to Program
44-10. If there is a match, the
pattern defined in that program is
used. If not, the F-Route pattern in
Program 44-09 and time setting in
Program 44-08 are used.
0 = Not Used
1 = Used
(default = 0)
44-02-01 Dial Analysis Table for ARS/
F-Route Access – Dial
Set the Dial digits for the
Pre-Transaction Table for
selecting ARS/F-Route (eight
digits max: 1~9, 0
* #, @). To
enter a wild card/don’t care digit,
press Line Key 1 to enter an @
symbol.
Up to eight digits
(Use line key 1 for a
‘Don’t Care’ digit, @)
(default not assigned)
44-02-02 Dial Analysis Table for ARS/
F-Route Access – Service Type
Set the Service Type (0~3) for the
Pre-Transaction Table for
selecting ARS/F-Route.
0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension
Analyze Table (Option)
(default = 0)
44-02-03 Dial Analysis Table for ARS/
F-Route Access – Additional
Data
If a Service Type is set to F-Route
in Program 44-02-02, set which
F-Route table to be used.
1=Delete Digit = 0~255
(255 : Delete All Digits)
2=0~500 (0 = No
Setting)
3=Dial Extension
Analyze Table Number
= 0~4
(0 = No Setting)
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data