NEC Univerge SV8100 - Page 119

UNIVERGE SV8100 Issue 5.0
Automatic Route Selection 1 - 109
44-02-04 Dial Analysis Table for ARS/
F-Route Access – Dial Tone
Simulation
Determine if the Dial Tone
Simulation is on (1) or off (0) for
the Pre-Transaction Table for
selecting ARS/F-Route. If
enabled, this option sends dial
tone to the calling party once the
routing is determined. This may be
required if the central office at the
destination does not send dial
tone.
0 = Off
1 = On
(default = 0)
44-03-01 Dial Analysis Extension Table –
Dial
Set the Dial digits (24 digits max:
1~9, 0
* #, @) to be used for the
Dial Extension Analysis Table.
When Program 44-02-02 is set to
type 3, this program sets the dial
extension analysis table. These
tables are used when the analyzed
digits must be more than eight
digits. To enter a wild card/don’t
care digit, press Line Key 1 to
enter an @ symbol.
Up to 24 digits
Digits = 1~9, 0,
*, #, @
(Press Line Key 1 for
wild character @)
(default not assigned)
44-03-02 Dial Analysis Extension Table –
ARS/F-Route Select Table
Number (1~250)
When dialed digits match the
setting in Program 44-03-01,
select the ARS/R-Route table
number (0~500) to be used for the
Dial Extension Analysis Table.
0~500
(ARS/F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
44-03-03 Dial Analysis Extension Table –
ARS/F-Route Select Table
Number (251)
If the received digits are not
identified in tables 1~250, the
F-Route selection table number
(0~500) defined in table 251 is
used.
0~500
(ARS/F-Route Table
Number)
With Program 44-01
set to 0, Program
44-05 is checked.
With Program 44-01
set to 1, Program
44-04 is checked.
(default = 0)
44-03-04 Dial Analysis Extension Table –
Next Table Area Number (252)
If the received digits do not match
the digits set in tables 1~250, table
number 252 is used refer to the
next Extension Table Area (1~4) to
be searched.
0~4
(default = 0)
44-04-01 ARS/F-Route Selection for Time
Schedule
Assign each ARS/F-Route
Selection number (1~500) to an
ARS/F-Route table number for
each ARS/F-Route time mode.
There are eight time modes for
ARS/F-Route Access.
ARS/F-Route Time
Mode: 1~8
ARS/F-Route Table
Number = 0~500
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data