NEC Univerge SV8100 - Page 120

Issue 5.0 UNIVERGE SV8100
1 - 110 Automatic Route Selection
44-05-01 ARS/F-Route Table – Trunk
Group Number
Select the trunk group number to
be used for the outgoing ARS call.
0~100, 255
0 = No Setting
255 = Extension Call
(default = 0)
44-05-02 ARS/F-Route Table – Delete
Digits
For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Enter the number of digits to
be deleted (0~255) from the dialed
number.
0~255
(255 = Delete All)
(default = 0)
44-05-03 ARS/F-Route Table – Additional
Dial Number Table
For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Enter the table number
(defined in Program 44-06) for
additional digits to be dialed
(0~1000).
0~1000
(default = 0)
44-05-04 ARS/F-Route Table – Beep Tone For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Select whether or not a
beep is heard if a lower priority
trunk group is used.
0 = Off (No Beep)
1 = On (Beep)s
(default = 0)
44-05-05 ARS/F-Route Table – Gain Table
Number for Internal Call
For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Select the gain table
number to be used for internal
calls (0~500).
0~500
0 = No Setting
(default = 0)
44-05-06 ARS/F-Route Table – Gain Table
Number for Tandem
Connections
For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Select the gain table
number to be used for the tandem
call (defined in Program 44-07).
0~500
0 = No Setting
(default = 0)
44-05-07 ARS/F-Route Table – ARS Class
of Service
For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Select the Class of Service
to be used for ARS (0~16).
Extension ARS COS is
determined in Program 26-04-01.
0~16
(default = 0)
44-05-08 ARS/F-Route Table – Dial
Treatment
For each ARS/F-Route table
(1~500) assign a priority number
(1~4). Select the Dial Treatment to
be used (0~15). The Dial
Treatments are defined in
Program 26-03-01
0~15
(default = 0)
44-05-09 ARS/F-Route Table – Maximum
Digit
Input the maximum number of
digits to send when using the
F-Route.
0~24
(default = 0)
44-05-10 ARS/F-Route – CCIS over IP
Destination Point Code
For each ARS/F-Route table
(1~500). Set the CCIS over IP
Destination Point Code (0~16367).
0~16367
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data