NEC Univerge SV8100 - Page 134

Issue 5.0 UNIVERGE SV8100
1 - 124 Barge-In
Operation
To Barge-In after calling a busy extension:
.
The time in Program 21-01-03 must expire before you can Barge-In.
1. Call a busy extension.
2. Press Barge-In key (Program 15-07-01 or SC 851: 34).
To Barge-In without first calling the busy extension:
1. Pick up the handset or press Speaker.
2. Dial 810.
- OR -
Press Barge-In key (Program 15-07-01 or SC 851: 34).
3. Dial busy extension.
. The extension user hears a warning tone.
. The DISA user is rerouted to the defined ring group.
. The Tie Line user hears a busy tone.
- OR -
The following steps are not available for DISA or Tie Line trunks:
1. Dial the extension number of the busy internal party.
20-13-32 Class of Service Options
(Supplementary Service) –
Multiple Barge-Ins
In an extension Class of Service,
allow (1) or deny (0) the extension
ability to have multiple users
Barge-In to their conversation.
0 = Off
1 = On
(default: 0 for COS
1~15)
20-14-11 Class of Service Options for
DISA/E&M – DISA/Tie Trunk
Barge-In
In an extension Class of Service,
enable (1) or disable (0) a DISA or
tie trunk user from using the
Barge-In feature.
0 = Off
1 = On
(default: 0 for COS
1~15)
20-18-07 Service Tone Timers – Intrusion
Tone Repeat Time
After a user barges in, the system
repeats the Barge-In tone after this
interval.
0~64800 seconds
(default = 0 seconds)
21-01-03 System Options for Outgoing
Calls – Trunk Interdigit Time
(External)
Program how long an extension
must wait before using the
Barge-In feature can be used on a
call (this timer waits until it expires
before putting a call in a talk state).
This timer also affects Voice Over.
0~64800 seconds
(default = 5 seconds)
Program
Number
Program Name Description/Comments Assigned Data