UNIVERGE SV8100 Issue 5.0
Account Code – Forced/Verified/Unverified 1 - 5
Conditions
z If a user enters a code that exceeds the 16 digit limit, the system ignores the Account Code
Entry.
z If the system has Account Codes disabled, the digits dialed (e.g., *1234*) appear on the
SMDR report as part of the number dialed.
z If using Forced Account Code with single line telephone you need a VRS to get the prompts
to enter the Forced Account Code.
z When you use Forced Account Code on only toll calls, and you dial a local call, you hear a
beep.
z Speed Dial – System/Group/Station bins can contain stored Account Codes. They can be
prevented from being displayed using Program 20-07-04.
z To simplify Account Code Entry, store the Account Code (e.g., *1234*) in a One-Touch Key.
Just press the key instead of dialing the codes.
z Account Codes appear on the SMDR report (even if they are hidden on the telephone
display).
z Do not use an asterisk within a PBX/CTX access code when using Account Codes. The *,
causes the trunk to stop sending digits to the central office until another
* is entered.
z Account Codes for incoming calls not available for single line telephones.
Default Settings
Account Codes are disabled.
System Availability
Terminals
Any Station
Required Component(s)
VRS for Forced Account Codes for Single Line Telephones
To Next Page
Loading...
