NEC Univerge SV8100 - Page 176

Issue 5.0 UNIVERGE SV8100
1 - 166 Call Forwarding, Off-Premise
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-09-01 DTMF and Dial Tone Circuit
Setup
Allocate the circuits on the
CD-CP00 ETUs for either DTMF
receiving or dial tone detection.
Program 14-01-13 Basic Trunk
Data Setup – Loop Supervision
Enable (1) loop supervision for
each trunk that should be able to
use Call Forwarding Off-Premise.
0 = Common Use
1 = Extension Only
2 = Trunk Only
Default:
Circuit/Resource
01~08 = 1 (Extensions)
Circuit/Resource
09~32 = 2 (Trunks)
Circuit/Resource
33~96 = 0 (Not Used)
Circuit/Resource
97~160 = 0 (Common)
When PZ-BS10 is
installed, 97~160 are
available
11-07-01 Department Group Pilot
Numbers – Dial
Use to assign pilot numbers to
each Department Group set up.
Up to eight digits
(default not assigned)
11-11-01 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– All
Use to assign the Call Forward All
Service Code.
MLT, SLT
(default = 848)
11-11-02 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– Busy
Use to assign the Call Forward
Busy Service Code.
MLT, SLT
(default = 843)
11-11-03 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– No Answer
Use to assign the Call Forward No
Answer Service Code.
MLT, SLT
(default = 845)
11-11-04 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– Busy/No Answer
Use to assign the Call Forward
Busy No Answer Service Code.
MLT, SLT
(default = 844)
11-11-05 Service Code Setup (for Setup/
Entry Operation) – Call Forward
– Both Ring
Use to assign the Call Forward
Both Ring Service Code.
MLT, SLT
(default = 842)
11-11-45 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward All (Split)
Use to assign the Call Forward All
Split Service Code.
MLT, SLT
(default not assigned)
11-11-46 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward Busy (Split)
Use to assign the Call Forward
Busy Split Service Code.
MLT, SLT
(default not assigned)
11-11-47 Service Code Setup (for Setup/
Entry Operation) – Set/Cancel
Call Forward No Answer (Split)
Use to assign the Call Forward No
Answer Split Service Code.
MLT, SLT
(default not assigned)