NEC Univerge SV8100 - Page 19

UNIVERGE SV8100 Issue 5.0
Account Code – Forced/Verified/Unverified 1 - 9
5. Dial the number you want to call.
To dial an outside number and let your system tell you when a Forced Account Code is required:
1. Access a trunk and dial the number you want to call.
2. Wait for your call to go through.
- OR -
3. If you hear “Please enter an Account Code,” (depending on system programming) and your
display shows ENTER ACCOUNT CODE.
o Dial *.
- OR -
Press your Account Code key (
Program 15-07-01 or SC 851: code 50).
o Dial your Account Code (3~16 digits, using 0~9 and #).
If Account Codes are hidden, each digit you dial shows an
* on the telephone display.
o Dial *.
- OR -
Press your Account Code key (
Program 15-07-01 or SC 851: code 50).
To enter an Account Code for an incoming call:
This procedure is not available for single line telephones.
1. Answer incoming call.
. If Account Codes for Incoming Calls is disabled, the following steps dial digits out onto the connected trunk.
2. Dial *.
3. Enter the Account Code (1~16 digits).
. You can enter any code of the proper length.
4. Dial *.
To enter a Forced Account Code at a single line telephone:
1. Access trunk for outside call.
. You can access a trunk by dialing a code. Refer to Central Office Calls, Placing for more information.
. With Forced Account Codes, you hear, “Please enter an Account Code.”(depending on programming).
2. Dial *.
3. Enter Account Code (3~16 digits).
4. Dial
*.
5. Dial number you want to call.