Issue 5.0 UNIVERGE SV8100
1 - 8 Account Code – Forced/Verified/Unverified
Operation
To enter an Account Code any time while on a trunk call:
The outside caller cannot hear the Account Code digits you enter. You can use this procedure if your
system has Optional Account Codes enabled. You may also be able to use this procedure for incoming
calls. This procedure is not available for single line telephones.
1. Dial
*.
- OR -
Press your Account Code key (Program 15-07-01 or SC 851: code 50).
2. Dial your Account Code (1~16 digits, using 0~9 and
#).
. If Account Codes are hidden, each digit you dial shows an “*” character on the telephone display.
3. Dial *.
- OR -
Press your Account Code key (Program 15-07-01 or SC 851: code 50).
To enter a Forced Account Code before dialing the outside number:
If your system has Forced or Verified Account Codes, you may use this procedure instead of letting the
system prompt you for your Account Code. You may also use this procedure if your system has Optional
Account Codes.
If your system has Verified Account Codes enabled, be sure to choose a code programmed into your
Verified Account Code list.
1. Access trunk for outside call.
. You can access a trunk by pressing a line key or dialing a code. Refer to Central Office Calls, Placing on page
1-245 for more information.
2. Dial *.
- OR -
Press your Account Code key (Program 15-07-01 or SC 851: code 50).
3. Dial your Account Code [1~16 digits, using 0~9 and
# or (3~16 digits for Forced)].
. If you make an incorrect entry, your system may automatically alert the operator. If Account Codes are hidden,
each digit you dial shows an
* on the telephone display (depending on programming).
4. Dial *.
- OR -
Press your Account Code key (Program 15-07-01 or SC 851: code 50).
To Next Page
Loading...
