UNIVERGE SV8100 Issue 5.0
Account Code – Forced/Verified/Unverified 1 - 7
35-05-01 Account Code Setup – Account
Code Mode
For each Class of Service (1~15)
use this option to select the
Account Code Mode.
0 = Account Codes
disabled. (Codes
entered dial out as part
of initial call.)
1 = Account Codes
optional (not required).
2 = Account Codes
required (forced) but
not verifiable.
3 = Account Codes
required (forced) and
verifiable.
(default = 0)
35-05-02 Account Code Setup – Forced
Account Code Toll Call Setup
Use this option to enable Account
Codes for all calls or just toll calls
(for mode 2 or 3 in Program
35-05-01).
0 = Account Codes for
toll and local calls (All)
1 = Account Codes just
for toll calls (STD)
(default = 0)
35-05-03 Account Code Setup – Account
Codes for Incoming Calls
For each Class of Service (1~15),
enter 1 in this option to enable
Account Codes for incoming calls.
Enter 0 to disable Account Codes
for incoming calls. If disabled, any
codes you enter dial out on the
connected trunk.
0 = Disable Account
Codes for incoming
calls
1 = Enable Account
codes for incoming
calls
(default = 0)
35-05-04 Account Code Setup – Hiding
Account Codes
For each Class of Service (1~15),
enter 1 to have the system hide
Account Codes on an extension
display as they are entered. Enter
0 to have the Account Codes
displayed.
0 = Account Codes
Displayed
1 = Account Codes not
Displayed
(default = 0)
35-06-01 Verified Account Code Table –
Verified Account Code
Use this option to enter data into
the Verified Account Code Table.
You can enter up to 2000 codes
from 3~16 digits in length. For a
wild card @, press the LK 1.
Up to 16 digits
Enter: 1~9, 0,
#, @
(@ = Wild Card)
(default not assigned)
40-10-01 Voice Announcement Service
Option – VRS Fixed Message
Used (1) or Not Used (0) the Fixed
VRS messages.
0 = Not Used
1 = Used
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
