NEC Univerge SV8100 - Page 225

UNIVERGE SV8100 Issue 5.0
Caller ID 1 - 215
20-08-15 Class of Service Options
(Outgoing Call Service) – Block
Outgoing Caller ID
Turn Off (0) or On (1) a user Class
of Service from automatically
blocking outgoing Caller ID
information when a call is placed.
If block is enabled, the system
automatically inserts the Caller ID
block code (defined in Program
14-01-21) before the user dialed
digits (this requires Program 14-
02-10 to be enabled). If block is
disabled, the system outdials the
call just as it was dialed by the
user.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-09-02 Class of Service Options
(Incoming Call Service) – Caller
ID Display
Turns Off (0) or On (1) the Caller
ID display at an extension.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-09-04 Class of Service Options
(Incoming Call Service) –
Notification for Incoming Call
List Existence
Determine whether or not the
CHECK LIST message is
displayed to indicate a missed call.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-13-06 Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
manually (0) or automatically (1)
receive off-hook signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-19-01 System Options for Caller ID –
Caller ID Displaying Format (If
displaying digits are more than
12 digits)
Determine whether the first 10
digits (0) or last 10 digits (1)
should be displayed when Caller
ID exceeds 12 digits.
0 = First 10 digits
(Upper)
1 = Last 10 digits
(Lower)
(default = 0)
20-19-05 System ID Options for Caller ID –
Caller ID Sender Queuing Time
(Sender Wait)
With the Caller ID Sender Queuing
option, determine how long an
incoming call will wait in queue for
a DSP resource to become
available. If a resource becomes
available during this time, the call
immediately rings the single line
telephone with Caller ID. If the
time expires before a resource
becomes available, the system
rings the single line telephone
without Caller ID (until the queuing
time expires, the single line
telephone does not ring). If the
queuing timer is set to "0", the
system does not queue the
incoming call.
0~64800 (seconds)
(default = 0 seconds)
Program
Number
Program Name Description/Comments Assigned Data