NEC Univerge SV8100 - Page 226

Issue 5.0 UNIVERGE SV8100
1 - 216 Caller ID
Operation
Storing a Number
To store a Caller ID number in an Speed Dial bin:
1. With a multiline terminal in an idle condition the display shows:
2. Press the LIST Softkey. The display shows:
3. Press the CID Softkey (Caller ID). The display shows:
20-20-01 Message Setup for Non-Caller ID
Data – Private Call
Enter the text to be displayed for
Caller ID when a user receives a
call which is classified as a private
call.
24 Alphanumeric
Characters
(default = PRIVATE)
20-20-02 Message Setup for Non-Caller ID
Data – Call from Out of Service
Area
Enter the text to be displayed for
Caller ID when a user receives a
call which is classified as an
out-of-service area call.
24 Alphanumeric
Characters
(default = OUT OF
AREA)
20-20-03 Message Setup for Non-Caller ID
Data – Call Information with
Error
Enter the text to be displayed for
Caller ID when a user receives a
call which is classified as a call
with a CID error.
24 Alphanumeric
Characters
(default = NO CALLER
INFO)
90-03-01 Save Data Use to save the programmed data
on the SRAM and Flash ROM to
the 16MB/32MB ATA removable
Compact Flash memory card.
Also, used to save stored Caller ID
if permanently saved with service
code #*#9 (11-15-03).
Dial 1 + press Hold
(Press Hold to cancel.)
90-04-01 Load Data Use to load the system data from
the inserted Compact Flash
Memory to the SRAM and Flash
ROM in the system.
Also, used to load stored Caller ID.
Dial 1 + press Hold
(Press Hold to cancel.)
1-01 FRI 09:00AM
301 STA 301
LIST DIR ICM PROG
LIST MENU
Redial CID
##: xxxxxxxxxxxxx
mm-dd hh:mm
Program
Number
Program Name Description/Comments Assigned Data