NEC Univerge SV8100 - Page 236

Issue 5.0 UNIVERGE SV8100
1 - 226 Caller ID – Flexible Ringing
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-10-32 Service Code Setup (for System
Administrator) – Set Private Call
Refuse
Enable/Disable the Private Call
Refuse (trunks) which are set in
Program 14-01-27.
MLT, SLT
(default not assigned)
11-10-33 Service Code Setup (for System
Administrator) – Entry Caller ID
Refuse
Add/Delete the Caller ID to refuse.
. This operation must be
performed from a Keyset.
MLT
(default not assigned)
11-10-34 Service Code Setup (for System
Administrator) – Set Caller ID
Refuse
Enable/Disable the Caller ID
number (trunks) which are set in
Program 14-01-27.
MLT, SLT
(default not assigned)
13-02-01 Group Speed Dialing Bins Designate the starting bin number
the system uses for Group Speed
Dialing.
01~64
(default not assigned)
13-04-01 Speed Dialing Number and Name
– Speed Dialing Data
Enter the System and Group
Speed Dialing numbers and
names.
1~9, 0, *, #
Pause (Press line key
1)
Recall/Flash (Press
line key 2)
@ = Code to wait for
answer supervision in
ISDN (Press line key 3)
(maximum 24 digits)
(default not assigned)
13-04-03 Speed Dialing Number and Name
– Transfer Mode
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
0 = Not Used
1 = Internal Dial
2 = Incoming Ring
Group (IRG)
(default = 0)
13-04-04 Speed Dialing Number and Name
– Transfer Destination Number
When the incoming caller ID
matches the number programmed
in the speed dial bin, this setting
determines the destination of the
call.
If Transfer mode is
(Refer to 13-04-03):
1 = Internal Dial Mode
1~9, 0, *, #, P, R, @
(Maximum 24
Characters)
2 = Incoming Ring
Group
0 ~ 100 (IRG Number)
P=Pause R=Recall
@= Additional Digits
when using ISDN
functionality
(default not assigned)