NEC Univerge SV8100 - Page 237

UNIVERGE SV8100 Issue 5.0
Caller ID – Flexible Ringing 1 - 227
The Caller ID – Flexible Ringing Flowchart below helps define programming:
13-04-05 Speed Dialing Number and Name
– Incoming Ring Pattern
Define the ring tone for the caller
ID routed call.
Incoming Ring Pattern
0 = Normal Pattern
1 ~ 4 = Tone Pattern
(1~4)
5 ~ 9 = Scale Pattern
(1~5)
(default = 0)
14-01-27 Basic Trunk Data Setup – Caller
ID Refuse Setup
Define if the trunk will reject the
call by playing the VRS message
based on the Caller ID
information.
0 = Disable (No)
1 = Internal Dial
2 = Enable (Yes)
(default = 0)
15-07-01 Programmable Function Keys Assign function key 86 (Set
Private Call Refuse) to Enable/
Disable trunks which are set in
Program 14-01-27 to “1”.
Assign function key 87 (Set Caller
ID Refuse) to Enable/Disable the
Caller ID Refusal (trunks) which is
set in Program 14-01-27 to “1”.
Line Key 1~48
0~99 (Normal Function
Code 751 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
752 by default)
20-07-24 Class of Service Options
(Administrator Level) – Set/
Cancel Private Call Refuse
Enable (1) or Disable (0) an
extension user ability to set or
cancel Private Call Refuse.
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-07-25 Class of Service Options
(Administrator Level) – Set/
Cancel Caller ID Refuse
Enable/Disable an extension
ability to set or cancel Caller ID
Refuse.
0 = Off
1 = On
(default = 0 for
COS 1~15)
40-10-06 Voice Announcement Service
Option – Set VRS Message for
Private Call Refuse (VRS Msg
Private Call)
Assign the VRS Message number
used as Private Call Refuse.
When Fixed message is set, VRS
message guidance is: Service
finished. Disconnect the line,
please.
0~101
(0 = No message)
(101 = Fixed message)
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data