NEC Univerge SV8100 - Page 248

Issue 5.0 UNIVERGE SV8100
1 - 238 Central Office Calls, Answering
20-10-07 Class of Service Options
(Answer Service) – Automatic
Off-Hook Answer
Turns Off (0) or On (1) an
extension to use Universal Auto
Answer (no service code
required).
0 = Off
1 = On
(default = 0 for
COS 1~15)
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
Turn Off (0) or On (1) the
extension ability to use Continued
Dialing, which allows DTMF signal
sending while talking on
extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-23 Class of Service Options
(Supplementary Service) –
Display the Reason for Transfer
Select whether an extension
should display the reason a call is
being transferred to their
extension (Call Forward Busy, Call
Forward No Answer, DND).
0 = Off
1 = On
(default = 0 for
COS 1~15)
21-01-15 System Options for Outgoing
Calls – Outgoing Disable on
Incoming Line (Toll Restriction)
Enable (1) or disable (0) the
Outgoing Disable on Incoming
Line feature.
0 = Disable
1 = Enable
(default = 0)
21-01-16 System Options for Outgoing
Calls – Supervise Dial Detection
Timer
With the Outgoing Disable on
Incoming Line feature, if dial tone
is not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
0~64800 (seconds)
(default = 20 seconds)
21-01-17 System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Digits 0~9
(default = 4)
22-01-01 System Options for Incoming
Calls – Incoming Call Priority
Use this option to determine if
Intercom calls or trunk calls have
answer priority when both are
ringing simultaneously.
0 = Intercom call
priority
1 = Trunk call priority
(default = 1)
22-01-02 System Options for Incoming
Calls – Incoming Call Ring No
Answer Alarm
Enable (1) or disable (0) the
Incoming Call RNA Alarm. If
enabled, the ring cadence will
change for a call that rings longer
than the interval set in Program
22-01-03.
0 = Disable
1 = Enable
(default = 0)
22-01-03 System Options for Incoming
Calls – Ring No Answer Alarm
Time
Set the Ring No Answer Alarm
interval. If a trunk rings a multiline
terminal longer than this interval,
the system changes the ring
cadence.
0~64800 (seconds)
(default = 60 seconds)
22-01-04 System Options for Incoming
Calls – DIL No Answer Recall
Time
A DIL that rings its programmed
destination longer than this
interval diverts to the DIL No
Answer Ring Group (set in
Program 22-08).
0~64800 (seconds)
(default = 0 seconds)
Program
Number
Program Name Description/Comments Assigned Data