NEC Univerge SV8100 - Page 258

Issue 5.0 UNIVERGE SV8100
1 - 248 Central Office Calls, Placing
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-03-XX ETU Setup Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
11-01-01 System Numbering Use to set system numbering plan. Refer to UNIVERGE
SV8100 Programming
Manual
11-09-01 Trunk Access Code If required, change the single-digit
Trunk Access Code (normally 9). If
you change this code, you must
also review the settings in
Program 11-01-01 for the new
code selected.
Dial (up to four digits)
(default = 9)
11-09-02 Trunk Access Code – 2nd Trunk
Route Access Code
Assign the Service Code set up in
Program 11-01-01 for Alternate
Trunk Route Access.
Dial (up to four digits)
(default not assigned)
11-10-27 Service Code Setup (for System
Administrator) – Trunk Port
Disable for Outgoing Calls
Define the service code which
should be used by an extension
user to block a trunk from being
used for outgoing calls.
MLT, SLT
(default = 745)
11-11-13 Service Code Setup (for Setup/
Entry Operation) – Display
Language Selection for Multiline
Terminal
Select the service code which can
be used at an extension to change
the displayed language on a
multiline terminal display
MLT
(default = 778)
11-12-01 Service Code Setup (for Service
Access) – Bypass Call
Define the service code for
Activating Call Forwarding/Do Not
Disturb Override. This code is
available only if you disable the
voice mail Single Digit dialing code
in Program 11-16-09.
MLT, SLT
(default = 807)
11-12-14 Service Code Setup (for Service
Access) – Trunk Group Access
Define the service code which
should be used by an extension
user to select outgoing Trunk
Group.
MLT, SLT
(default = 804)
14-01-01 Basic Trunk Data Setup – Trunk
Name
Set the names for trunks. The
trunk name displays on a multiline
terminal for incoming and outgoing
calls.
Up to 12 Characters
Line 001
Line 002
Line 003
:
Line 200