NEC Univerge SV8100 - Page 259

UNIVERGE SV8100 Issue 5.0
Central Office Calls, Placing 1 - 249
14-01-02 Basic Trunk Data Setup –
Transmit Level
Customize the transmit and
receive levels of the CODEC Gain
Types for each trunk.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
14-01-03 Basic Trunk Data Setup –
Receive Level
Customize the transmit and
receive levels of the CODEC Gain
Types for each trunk.
Trunks 1~200
1~63
(-15.5 ~ +15.5dB in
0.5dB intervals)
[default = 32 (0dB)]
14-01-07 Basic Trunk Data Setup –
Outgoing Calls
Use this option to allow (1) or
prevent (0) outgoing calls on the
trunk you are programming.
0 = Deny (No)
1 = Allow (Yes)
(default = 1)
14-01-10 Basic Trunk Data Setup – DTMF
Tones for Outgoing Calls
For each trunk, enable (1) or
disable (0) the ability to hear the
DTMF of the digits dialed when
placing the outgoing call.
0 = Disable
1 = Enable
(default = 0)
14-02-05 Analog Trunk Data Setup – Dial
Tone Detection for Manually
Accessed Trunks
Use this option enable/disable dial
tone detection for directly
accessed trunks. If disabled, the
system outdials on the trunks
without monitoring for dial tone.
0 = Dial Tone Detection
Not Used
1 = Dial Tone Detection
Used
(default = 0)
14-02-11 Analog Trunk Data Setup – Next
Trunk in Rotary if No Dial Tone
Use this option to enable (1) or
disable (0) the system ability to
skip over a trunk if dial tone is not
detected. This option pertains to
calls placed using Call
Appearance (CAP) Keys, Speed
Dial, Automatic Route Selection
(ARS), Last Number Redial or
Save Number dialed. It does not
pertain to line key or Direct Trunk
Access calls.
0 = Disable
1 = Enable
(default = 0)
14-02-14 Analog Trunk Data Setup – Loop
Start/Ground Start
Select loop start (0) or ground start
(1) for the trunk.
0 = Loop Start (Loop)
1 = Ground Start
(Ground)
(default = 0)
14-05-01 Trunk Group – Trunk Group
Number
Assign trunks to Trunk Groups.
You can also assign the outbound
priority for trunks within the group.
When users dial up the trunk
group, they seize the trunks in the
order you specify in the outbound
priority entry.
. At default, all group are
assigned to Trunk Group 1.
Trunk Group Number:
0~100
Priority Number:
1~200
(default = Trunk Group
1, with priority in
ascending order)
Program
Number
Program Name Description/Comments Assigned Data