UNIVERGE SV8100 Issue 5.0
Central Office Calls, Placing 1 - 253
21-01-17 System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Digits 0~9
(default = 4)
21-02-01 Trunk Group Routing for
Extensions
Assign Program 14-06 routes to
extensions.
0~100
(0 = No Setting)
(default = 1)
21-15-01 Individual Trunk Group Routing
for Extensions
Designate the trunk route
accessed when a user dials the
Alternate Trunk Route Access
Code. Refer to Trunk Group
Routing to set up outbound
routing.
0~100
(0 = No Setting)
(default = 0)
24-02-07 System Options for Transfer –
Trunk-to-Trunk Transfer Release
Warning Tone
Timer starts when a trunk begins
talking with another trunk (for
example: Trunk-to-Trunk Transfer,
outgoing from trunk, Tandem
Trunking). When this time expires,
a warning tone is heard.
0~64800 (seconds)
(default = 1800
seconds)
24-02-10 System Options for Transfer –
Disconnect Trunk to Trunk Timer
Timer starts after the Warning
Tone is heard (24-02-07). When
time expires, the trunk is
disconnected.
0~64800 (seconds)
(default = 0 seconds)
82-08-01 Sidetone Volume Setup Use this program to adjust the
multiline terminal side tone
volume. There are two levels,
based on whether the connected
trunk is a digital trunk or analog
trunk.
0-9
Digital Sidetone Level
0 = -54 (db)
1 = -48 (db)
2 = -42 (db)
3 = -36 (db)
4 = -30 (db)
5 = -24 (db)
6 = -18 (db)
7 = -12 (db)
8 = -12 (db)
9 = -12 (db)
Analog Sidetone Level
0 = -54 (db)
1 = -54 (db)
2 = -54 (db)
3 = -48 (db)
4 = -42 (db)
5 = -36 (db)
6 = -30 (db)
7 = -24 (db)
8 = -18 (db)
9 = -12 (db)
Program
Number
Program Name Description/Comments Assigned Data
To Next Page
Loading...
