NEC Univerge SV8100 - Page 262

Issue 5.0 UNIVERGE SV8100
1 - 252 Central Office Calls, Placing
15-13-02 Loop Key - Incoming Used to define an incoming loop
key
0~100(0 = Assigns
Loop Key to all Trunk
Groups
1~100 = Assigns Loop
Key to specified Trunk
Group
20-02-06 System Options for Multiline
Telephones – Preselection Time
Set the preselection time When a
multiline terminal user preselects a
line key, the system remembers
the preselection for this time.
0~64800 (seconds)
(default = 5 seconds)
20-02-09 System Options for Multiline
Telephones – Disconnect
Supervision
Use this option to enable (1) or
disable (0) disconnect supervision
for the system trunks.
0 = Disable
1 = Enable
(default = 1)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension port =
Class 1
20-07-12 Class of Service Options
(Administrator Level) – Trunk
Port Disable
Turn Off (0) or On (1) the
extension ability to use the Trunk
Port Disable feature.
0 = Off
1 = On
(default = 0 for
COS 1~14)
(default = 1 for
COS 15)
20-08-02 Class of Service Options
(Outgoing Call Service) – Trunk
Outgoing Calls
Turns off (0) or on (1) outgoing
trunk calling for the extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-13 Class of Service Options
(Supplementary Service) –
Continued Dialing (DTMF) Signal
on ICM Call
Turn Off (0) or On (1) the
extension ability to use Continued
Dialing, which allows DTMF signal
sending while talking on
extension.
0 = Off
1 = On
(default = 1 for
COS 1~15)
21-01-15 System Options for Outgoing
Calls – Outgoing Disable on
Incoming Line (Toll Restriction)
Enable or Disable the Outgoing
Disable on Incoming Line feature.
0 = Disable
1 = Enable
(default = 0)
21-01-16 System Options for Outgoing
Calls – Supervise Dial Detection
Timer
With the Outgoing Disable on
Incoming Line feature, if dial tone
is not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
0~64800 (seconds)
(default = 20 seconds)
Program
Number
Program Name Description/Comments Assigned Data