NEC Univerge SV8100 - Page 298

Issue 5.0 UNIVERGE SV8100
1 - 288 Code Restriction
21-01-15 System Options for Outgoing
Calls – Outgoing Disable on
Incoming Line (Toll Restriction)
Enable or disable the Incoming
Line feature system wide. When
enabled applies code restriction
when hook flash is sent on
inbound trunk followed by dialed
digits.
0 = Disable
1 = Enable
(default = 0)
21-01-16 System Options for Outgoing
Calls – Supervise Dial Detection
Timer
With the Outgoing Disable on
Incoming Line feature, if dial tone
is not detected after the extension
answers an incoming line, the
system determines the call is
unable to complete and releases
the DTMF receiver.
0~64800 (seconds)
(default = 20 seconds)
21-01-17 System Options for Outgoing
Calls – Restriction Digit in
Outgoing Disable on Incoming
Line
With the Outgoing Disable on
Incoming Line feature, determine
the number of digits (0~9) to be
dialed before the call should be
disconnected.
Digits 0~9
(default = 4)
21-04-01 Toll Restriction Class for
Extensions
Use to assign a Toll Restriction
class to an extension for modes
1-8.
Day/Night Mode
1~9 (9 = Power Failure
Mode)
1~15
(default = 2)
21-05-01 Toll Restriction Class –
International Call Restriction
Table
For the Toll Restriction Class you
select, assigned (1) or unassigned
(0) the International Call Restrict
Table (Program 21-06-01).
0 = Unassigned (No)
1 = Assigned (Yes)
default:
1, 6~15 = 0
2~5 = 1
21-05-02 Toll Restriction Class –
International Call Permit Code
Table
For the Toll Restriction Class you
select, assign (1) or unassign (0)
the International Call Permit Table
(Program 21-06-02).
0 = Unassigned
1 = Assigned
default:
1, 3~15 = 0
2 = 1
21-05-04 Toll Restriction Class –
Maximum Number of Digits Table
Assignment
Select the table (defined in
Program 21-06-03) to be used to
determine the maximum number
of digits allowed for outgoing calls.
1~4 =Table
0 =Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
21-05-05 Toll Restriction Class – Common
Permit Code Table
It chooses whether the table set
up by Program 21-06-04 is
referred to, or not referred to.
0 = Unassigned
1 = Assigned
Default:
1, 8~15 = 0
2~7 = 1
Program
Number
Program Name Description/Comments Assigned Data