NEC Univerge SV8100 - Page 299

UNIVERGE SV8100 Issue 5.0
Code Restriction 1 - 289
21-05-06 Toll Restriction Class – Common
Restriction Table
It chooses whether the table set
up by Program 21-06-05 is
referred to, or not referred to.
0 = Unassigned
1 = Assigned
Default:
1, 6~15 = 0
2~5 = 1
21-05-07 Toll Restriction Class – Permit
Code Table
Set the tables 1~4 when referring
to the table set up by Program
21-06-06.
1~4 =Table
0 = Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
21-05-08 Toll Restriction Class –
Restriction Table
Set the tables 1~4 when referring
to the table set up by Program
21-06-07.
1~4 =Table
0 = Disable (None)
Default:
1, 2, 6~15 = 0
3 = 1
4 = 2
5 = 3
21-05-09 Toll Restriction Class –
Restriction for Common Speed
Dials
For the Code Restriction Class
you select, enable (1) or disable
(0) Code Restriction for Common
Speed Dialing numbers.
0 = Does Not Restrict
1 = Following
Restriction Check
(default =0)
21-05-10 Toll Restriction Class –
Restriction for Group Speed
Dials
For the Toll Restriction Class you
select, enable (1) or disable (0)
Code Restriction for Group Speed
Dialing numbers.
0 = Does Not Restrict
1 = Following
Restriction Check
(default =0)
21-05-11 Toll Restriction Class – Intercom
Call Restriction
For the Toll Restriction Class you
select, enable (1) or disable (0)
Intercom Call Restriction. If
enabled, extensions cannot place
or receive Intercom calls.
0 = Disable
1 = Enable
(default = 0)
21-05-12 Toll Restriction Class – PBX Call
Restriction
For the Toll Restriction Class you
select, enable (1) or disable (0)
PBX Call Restriction.
1~4 =Table
0 = Disable (None)
Default:
1~6, 8~15 = 0
7 = 1
21-05-13 Toll Restriction Class –
Restriction of Tie Line Calls
Select whether or not the Toll
Restriction set up in Program
34-08-01 is enabled (1) or
disabled (0).
0 = Disable
1 = Enable
(default = 0)
21-06-01 Toll Restriction Table Data Setup
– International Call Restriction
Table
Enter the international dialing
codes you want to restrict.
Dial (Up to four digits)
default:
Tables 1
~10 = No
Setting
Program
Number
Program Name Description/Comments Assigned Data