NEC Univerge SV8100 - Page 311

UNIVERGE SV8100 Issue 5.0
Code Restriction Override 1 - 301
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-11-34 Service Code Setup (for Setup/
Entry Operation) – Temporary
Toll Restriction Override
If required, change the service
code (875) for Temporary Toll
Restriction Override.
MLT, SLT
(default = 875)
11-11-36 Service Code Setup (for Setup/
Entry Operation) – Toll
Restriction Override
If required, change the service
code (763) for Toll Restriction
Override.
MLT, SL7
(default = 763)
20-08-06 Class of Service Options
(Outgoing Call Service) –
Temporary Toll Restriction
Override
Turn off or on Temporary Toll
Restricting Override (Service
Code 875).
0 = Off
1 = On
(default = 0 for
COS 1~15)
21-01-07 System Options for Outgoing
Calls – Toll Restriction Override
Time
Set the Toll Restriction Override
Time. After dialing the Toll
Restriction Override codes, the
system removes Toll Restriction
for this Time.
0~64800 (seconds)
(default = 10 seconds)
21-07-01 Toll Restriction Override
Password Setup
Assign Toll Restriction Override
codes to extensions. Each code
must have four digits, using any
combination of 0~9,
# and *. Each
extension can have a separate
code, or many extensions can
share the same override code.
Maximum four digits
(0~9,
#, *)
(default not assigned)
21-14-01 Walking Toll Restriction
Password Setup – User ID
Enter the Walking Toll Restriction
Override User ID codes (six digits)
into tables. Up to 500 different
override codes can be entered.
Dial (Six digits)
(default not assigned)
21-14-02 Walking Toll Restriction
Password Setup – Walking Toll
Restriction Class Number
Enter the Walking Toll Restriction
Class of Service (1~15) to be used
for each table number assigned in
Program 21-14-01.
1~15
(default = 1)
35-02-01 SMDR Output Options – Toll
Restricted Call
SMDR can include or exclude calls
blocked by Toll Restriction.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-02 SMDR Output Options – PBX
Calls
When the system is behind a PBX,
SMDR can include all calls or just
calls dialed using the PBX trunk
access code.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-03 SMDR Output Options – Trunk
Number or Name
Select whether the system should
display the trunk name (0) or the
number (1) on SMDR reports.
. If this option is set to 0,
Program 35-02-14 must be
set to 0.
0 = Name
1 = Number
(default = 1)