NEC Univerge SV8100 - Page 312

Issue 5.0 UNIVERGE SV8100
1 - 302 Code Restriction Override
35-02-04 SMDR Output Options –
Summary (Daily)
Set this option to (1) to have the
SMDR report provide a daily
summary (at midnight every night).
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-05 SMDR Output Options –
Summary (Weekly)
Set this option to (1) to have the
SMDR report provide a weekly
summary (every Saturday at
midnight).
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-06 SMDR Output Options –
Summary (Monthly)
Set this option to (1) to have the
SMDR report provide a monthly
summary (at midnight on the last
day of the month).
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-07 SMDR Output Options – Toll
Charge Cost
Set this option to (1) have the
SMDR report include toll charges.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-08 SMDR Output Options –
Incoming Call
Enable this option (1) to have the
SMDR report include incoming
calls. If you disable this option (0),
incoming calls do not print.
0 = Not Displayed
1 = Displayed
(default = 1)
35-02-09 SMDR Output Options –
Extension Number or Name
Set this option (1) to have the
SMDR report include extension
numbers. Set this option (0) to
have the SMDR report include
extension names.
0 = Name
1 = Number
(default = 1)
35-02-10 SMDR Output Options – All
Lines Busy (ALB) Output
Determine if the All Lines Busy
(ALB) indication should be
displayed.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-12 SMDR Output Options – DID
Table Name Output
Determine if the DID table name
should be displayed.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-13 SMDR Output Options – CLI
Output When DID to Trunk
Determine if the CLI output should
be displayed for DID.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-14 SMDR Output Options – Date Determine whether the date
should be displayed on SMDR
reports.
. This option must be set to 0 if
the trunk name is set to be
displayed in Program
35-02-03.
0 = Not Displayed
1 = Displayed
(default = 0)
35-02-15 SMDR Output Options – CLI/DID
Number Switching
Determine whether or not the CLI/
DID Number Switching should be
displayed.
0 = CLI (CLIP)
1 = DID Calling
Number
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data