NEC Univerge SV8100 - Page 326

Issue 5.0 UNIVERGE SV8100
1 - 316 Conference
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
11-12-08 Service Code Setup (for Service
Access) – Barge-In
Determine what the service code
should be for an internal party to
use the Barge-In feature.
MLT, SLT
(default = 810)
11-12-47 Service Code Setup (for Service
Access) – Call Waiting Answer/
Split Answer
If required, use this program to
change the code users dial to Split
while on a call.
SLT
(default = 894)
11-12-57 Service Code Setup (for Service
Access) – Tandem Trunking
With two trunks in Conference
press the Hold key and dial 753
and the Conference/Tandem
happens.
MLT, SLT
(default = 753)
11-12-58 Service Code Setup (for Service
Access) – Transfer Into
Conference
If required, change the service
code used to transfer a call into a
Conference call.
MLT, SLT
(default not assigned)
11-16-02 Single Digit Service Code Setup
– Barge-In
Use to customize the one-digit
Service Codes used for Barge-In.
(default not assigned)
14-01-04 Basic Trunk Data Setup –
Transmit Gain Level for
Conference and Transfer Calls
Use to select the CODEC gain
type used by the trunk when it is
part of an unsupervised
conference.
1~63(-15.5dB ~
+15.5dB in 0.5dB
intervals)
[default = 32 (0dB)]
15-02-24 Multiline Telephone Basic Data
Setup – Conference Key Mode
This option allows an extension
Conf key to be programmed for
Conference or for Transfer. When
set for Transfer (1), the user
places a call on hold, dials the
extension to which it should be
transferred, the presses the Conf
key. The call is then transferred.
When set for Conference (0), with
an active call, the user presses the
Conf key, places a second call,
then presses the Conf key twice.
All the calls are then connected.
0 = Conference
1 = Transfer
(default = 0)
15-07-01 Programmable Function Keys Use to assign functions to multiline
terminal line keys.
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
All extension ports =
Class 1