NEC Univerge SV8100 - Page 361

UNIVERGE SV8100 Issue 5.0
Department Calling 1 - 351
20-06-01
Class of Service for Extensions
Assign a Class of Service (1~15)
to extensions.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1
20-09-07
Class of Service Options
(Incoming Call Service) – Call
Queuing
Turn Off (0) or On (1) an extension
ability to have calls queued if a call
rings the extension when it is
busy.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-11-17
Class of Service Options (Hold/
Transfer Service) – Department
Group Trunk-to-Trunk Transfer
(Each Telephone Group Transfer)
Turn On (1) or Off (0) the ability of
an extension in a Department
Group to use the Trunk-to-Trunk
Forwarding service codes.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-06
Class of Service Options
(Supplementary Service) –
Automatic Off-Hook Signaling
(Automatic Override)
Allows a busy extension ability to
manually (0) or automatically (1)
receive Off-Hook signals.
0 = Off
1 = On
(default = 1 for
COS 1~15)
20-13-14
Class of Service Options
(Supplementary Service) –
Department Calling (PLT No
Called Extension)
Turns off or on an extension user
ability to call a Department Group
Pilot.
0 = Off
1 = On
(default = 1 for
COS 1~15)
22-02-01
Incoming Call Trunk Setup –
Incoming Type
If you want a trunk to be a DIL to a
Department Group, assign Service
Type 4 for each Night Service
Mode. Refer to Program 22-07-01.
0 = Normal
1 = VRS (second dial
tone if no VRS
installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-07-01
DIL Assignment
For each trunk assigned Service
Type 4 in Program 22-02-01
above, assign the DIL destination
as the Department Group pilot
number (as assigned in Program
11-07-01).
Extension Number
(maximum eight digits)
(default not assigned)
Program
Number
Program Name Description/Comments Assigned Data