NEC Univerge SV8100 - Page 403

UNIVERGE SV8100 Issue 5.0
Direct Inward Dialing (DID) 1 - 393
Guide to Feature Programming
Program
Number
Program Name Description/Comments Assigned Data
10-03-01 ETU Setup Use program 10-03-XX to setup
and confirm the basic
configuration data for each blade.
This program represents different
data depending on the blade
installed in the slot. Please refer
the SV8100 Programming Manual
for a more detailed description of
this program.
The assigned data
varies depending on
the blade installed in
the slot. Please refer
to the SV8100
Programming Manual
for a more detailed
description of the
10-03-XX programs.
14-05-01 Trunk Group – Trunk group
Number
Put DID trunks in the same trunk
group (other than group 1). If you
have several types of DID trunks,
put each type in a separate trunk
group.
Trunks 1-200
Trunk Group 1-100
Priority 1-200
Default = All trunks in
Trunk Group 1 with
priority in trunk order.
Trunk 1 priority = 1
Trunk 200 priority =
200.
15-07-01 Programmable Function Keys You can assign line or Call
Appearance (CAP) Keys for DID
trunks (Trunks: 1~200).
Line Key 1~48
0~99 (Normal Function
Code 851 by default)
*00 ~ *99
(Appearance Function
Code) (Service Code
852 by default)
20-06-01 Class of Service for Extensions Assign a Class of Service (1~15)
to an extension.
Day Night/Mode: 1~8
Class of Service of
Extensions (1~15)
Default:
Extension port 101 =
Class 15
All other extension port
= Class 1