NEC Univerge SV8100 - 47-03 Group Mailbox Options

UNIVERGE SV8100 Issue 5.0
Direct Inward Dialing (DID) 1 - 397
22-11-11 DID Translation Number
Conversion – Ring Group
Transfer
Enable (1) or disable (0) each
conversion table to follow the Ring
Group programming defined in
Program 22-12-01 : DID Intercept
Ring Group. If Program 22-11-05 :
DID Translation Number
Conversion, Transfer Destination
Number 1 and Program 22-11-06 :
DID Translation Number
Conversion, Transfer Destination
Number 2 are set, the priority of
transferring is in this order:
Program 22-11-05 then Program
22-11-06 then if Program 22-11-11
is enabled, Program 22-12-01.
0 = Disable (Caller
hears Ringback)
1 = Enable (Go to
normal ring)
(default = 1)
22-12-01 DID Intercept Ring Group For each DID Translation Table,
program the DID Intercept
destination. The destination can
be a Ring Group, In-Skin/External
Voice Mail, or Centralized Voice
Mail. This program is used when
there is no destination
programmed in Program
22-11-05. It is unrelated to
Program 22-11-06 and Program
22-11-07.
0 (No Setting)
1~100 (Incoming Ring
Group)
102 (In-Skin/External
Voice Mail or InMail)
(default = 1)
22-13-01 DID Trunk Group to Translation
Table Assignment
Assign the DID trunk groups to
translation tables. If all the DID
trunks use the same type of DID
service, you may have only one
DID trunk group and one DID
Translation Table (with many
entries).
0~20
(0 = No Setting)
(default = 1)
25-01-01 VRS/DISA Line Basic Data Setup
– VRS/DISA Dial-In Mode
Determine whether the system
should use option 0 (Extension
number/Service code specify) or
option 1 (Use dial conversion
table) for calls.
0 = Extension Number
Service Code Specify
(Intercom)
1 = Use Dial
Conversion Table
(default = 0)
25-01-03 VRS/DISA Line Basic Data Setup
– VRS/DISA Transfer Alarm
Determine whether the system
should use option 0 (Normal) or
option 1 (Alarm) for calls.
0 = Normal
1 = Alarm
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data