NEC Univerge SV8100 - Page 406

Issue 5.0 UNIVERGE SV8100
1 - 396 Direct Inward Dialing (DID)
22-11-04 DID Translation Number
Conversion – Transfer Operation
Mode
For each DID Translation Table
entry (1~2000), specify the
condition required to transfer the
call to the destination defined in
Program 22-11-05 and Program
22-11-06.
0 = No Transfer
1 = Busy
2 = No Answer
3 = Both
(default = 0)
22-11-05 DID Translation Table Number
Conversion – Transfer
Destination Number 1
Use to define the 1st transfer
destination for each tables
received number.
0 = No Setting
1~100 = Incoming
Group
101 = (Not Used)
102 = In-Skin/External
Voice Mail or InMail
201~264 = Extension
Group
400 = Valid Extension
Number
401 = DISA
501~599 = DISA/VRS
Message
1000~999 = Speed
Number
(000~999)
(default = 0)
22-11-06 DID Translation Table Number
Conversion – Transfer
Destination Number 2
400 = Allows the outside party to
dial a different extension number
in the translation table (for
example, ring no answer to a
dialed number, the caller then
hears a dial tone, allowing them to
enter another Valid Extension
Number).
401 = Provides the caller with
DISA dialing options (requires
using the DISA password).
Note: This applies to 22-11-05 and
22-11-06.
. If the Transfer Destinations
are busy or receive no
answer, those calls are
transferred to the final
transfer destination (Program
22-10).
22-11-07 DID Translation Number
Conversion – Call Waiting
For each DID Translation Table
entry (1~2000), specify whether or
not Call Waiting should be allowed
(0 = Disable, 1 = Enable).
0 = Disable (No)
1 = Enable (Yes)
(default = 0)
22-11-08 DID Translation Number
Conversion – Maximum Number
of DID Calls
For each DID Translation Table
entry (1~2000), specify the
maximum number of DID calls.
0~200 (0 = No Limit)
(default = 0)
22-11-09 DID Translation Number
Conversion – Music On Hold
Source
For each DID Translation Table
entry (1~2000), specify the source
of music to be used for DID trunks.
0 = IC/MOH Port
1 = BGM Port
2 = ACI Port
(default = 0)
22-11-10 DID Translation Number
Conversion – ACI Music Source
Port
For each DID Translation Table
entry (1~2000), if item 2 is
selected in Program 22-11-09,
specify the port to be used for the
source of music heard on DID
trunks.
When a sound source
type is 2 in above :
(0~96)
(default = 0)
Program
Number
Program Name Description/Comments Assigned Data