NEC Univerge SV8100 - Page 417

UNIVERGE SV8100 Issue 5.0
Direct Inward Line (DIL) 1 - 407
Operation
To answer a call on your Direct Inward Line:
1. Lift the handset.
2. Press the flashing line key for DIL on the multiline terminal.
22-02-01 Incoming Call Trunk Setup Assign each DIL Service Type 4.
Make an entry for each Night
Service mode.
Trunks 1~200
0 = Normal
1 = VRS (second
dial tone if no
VRS installed)
2 = DISA
3 = DID
4 = DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID(DDI) Mode
Switching
(default = 0)
22-04-01 Incoming Extension Ring Group
Assignment
Assign the extensions that should
receive the overflow to the ring
group programmed in Program
22-08. Set the ringing in Program
22-06.
Maximum eight digits
Default:
Extensions 101~108
(first eight ports) ring
for incoming Ring
Group 1 calls. No
other extensions ring
for incoming Ring
Group 1 calls.
22-07-01 DIL Assignment Set the destination extension
number for each DIL – for each
Night Service mode. The
destination can be an extension
port, virtual extension number, or
Department Group pilot number
(as assigned in Program
11-07-01).
Extension Number
(maximum eight digits)
(default not assigned)
22-08-01 DIL/IRG No Answer Destination For each DIL with delayed ringing,
enter the DIL No Answer Ring
Group. An unanswered DIL rings
this group after the DIL No Answer
Time. Make an entry for each
Night Service mode.
0 (No Setting)
001~100
(Incoming Ring Group)
102 (In-Skin/
External Voice Mail
or InMail)
(default = 1)
Program
Number
Program Name Description/Comments Assigned Data